If you lift, do CrossFit or HYROX, or train BJJ, there’s a good chance you’ve felt this one. A sharp, very localised pain right on top of the shoulder when you bench, dip, do push-ups or reach across your body. Sometimes it spreads up into the upper trap and side of the neck.
That pattern often points to the acromioclavicular (AC) joint, where the collarbone meets the top of the shoulder blade.
The take-home
Pain on top of the shoulder with pressing is common and usually very manageable. Tweak technique, adjust load and positions, and keep building strength around it.
In this article

Where AC joint pain shows up
Studies that injected a harmless irritant into different parts of the shoulder found distinct pain maps:
- Irritating the area under the acromion (where the rotator cuff sits) caused pain down the outside of the upper arm.
- Irritating the AC joint caused pain right on top of the shoulder, spreading into the upper trapezius and side of the neck.
So where your pain is gives us a useful early clue.

How we test for it
There’s no single perfect test, but a combination works well. We typically check:
- Reaching across your body, which compresses the joint
- Resisted extension, pushing your arm backwards against resistance
- A specific shoulder test where pain on top of the shoulder (rather than deep inside) is the giveaway
- Pressing gently on both AC joints to compare sides
If two or more of these are positive, the AC joint becomes much more likely.
An interesting strength pattern also helps. With rotator cuff problems, people are usually weaker turning the arm out. With AC joint problems, people are often noticeably weaker turning the arm in.
Why it gets sore
Apart from obvious injuries (falling onto the point of the shoulder, which can sprain or separate the joint), the gradual-onset version often comes from repeated knocking of the end of the collarbone against the acromion. Heavy pressing volume, especially when the shoulder blades are rounding forwards at the bottom of a rep, and slumped desk postures can both contribute. Scans sometimes show irritation in the bone at the end of the collarbone.

Keeping you training while it settles
The aim isn’t to stop everything. It’s to reduce the specific stress on the joint while you keep building strength.
Modify pressing
- If you keep benching or doing push-ups, keep your shoulder blades gently pulled back throughout the whole rep, both down and up. Letting them roll forwards at the top or bottom is what tends to grind the joint.
- Reduce range temporarily, for example floor press or board press.
- Swap some pressing for triceps work and controlled flyes while the joint is grumpy.
Avoid cross-body loading
- Back off movements that jam the arm across the body, like certain stretches and some grappling positions, until it settles.
Be careful with rotation band work by your side
- These can tilt the shoulder blade and aggravate the joint. We’ll pick better alternatives.
Fix the 9-to-5
- If you spend all day hunched forward, your joint is being loaded long before you get to the gym. Small setup changes and movement breaks help.
Build the rest of the shoulder
- Upper back, rotator cuff and shoulder blade strength all help the joint tolerate load better when you return to full training.
When to get it checked
If you’ve had a fall onto the shoulder and there’s a visible step or bump on top, significant swelling, or you can’t lift your arm, see us or your GP promptly. AC joint sprains are graded, and higher grades may need specialist input.
Thanks for reading! If this sounds like you, I’d love to help you work out what’s going on and build a plan that fits your life.
This article is general information only and isn’t a substitute for personalised advice. Everyone is different, so if you’re unsure, book an assessment or speak with your GP. If you have severe or rapidly worsening symptoms, seek urgent medical care.

